Automatic Analysis Sequence
September 2018
The sequence of steps in running Automatic Track Counting in FastTracks is as follows...
September 2018
The sequence of steps in running Automatic Track Counting in FastTracks is as follows...
September 2018
With this tool selected you can click out a polygon to define the region of interest...
September 2018
Once the automatic count has been completed, click on the Area filter to open the Track Filters window...
September 2018
A manual review and editing of the identified tracks is the essential final step in establishing the track count...
September 2018
If the Detect Scratches option was selected in the Analysis Settings window, then probable polishing...
September 2018
The Azimuth direction of the c-axis can be set either manually, using the c-axis Tool in the...
September 2018
The track etch pit diameter parameters, Dpar and Dper, can be determined manually...
September 2018
Confined track and semi-track lengths can be determined in either 2D and 3D using FastTracks...
September 2018
There are several reasons why no tracks might appear after the Automatic Counting routine...